If you want a drilled hole in your domino, drill it before stamping.  We use a Dremel tool & a 3/16" or smaller drill bit.  Mark your holes before drilling.

Before stamping, you don't have to pre-treat the domino surface.  Simply stamp the image onto the domino with the ZimInk color of your choice.  It will dry in about 15 seconds.
Basic ZimInk instructions. 

There are lots of ways to add color to the stamped domino.  Any color can be applied directly on top of the ZimInked image.  These are a few techniques that we like:
*Fabrico markers can be colored directly onto the domino.   It can be smeared or gently lifted off with your finger or a q-tip, if you want subtle color. 
*Pearl Powders (or other metallic pigment powders) can be dusted onto tacky Fabrico ink.  Use your finger to smear the powder where you want it.  Lightly heat-set the Fabrico ink when you're done.
*Using a cosmetic makeup wedge, sponge metallic ZimInk around the edges of the domino.  We also like to sponge metallic ZimInk on the back of the domino.

Apply 2 coats of Glass Kote for a thick, glossy finish. 

Home
Online Shopping
Conventions & Classes
Projects, & Instructions
Specials
Monthly Rubber Stamps Club
Email a ZimPerson